Installation Steps of Different Weather Shields

PRODUCT

Weather Shields / Visors / Window Deflectors

 

Installation Steps of Regular Weather Shields (Adhesive-tape applied only)

1. Hold up the visors to the door frame to ensure they are correctly aligned.
2. Use a cleaning wipe to clean the areas where the visors will be installed, make sure the area is dry before proceeding to the next step.
3. Apply adhesive promoter on the surface of vehicle where you intend to stick visors on.
4. Tear off 5-10cm of each side of the adhesive tape. Apply pressure to the visor while slowly peeling back the tape, press down firmly to ensure a strong bond.
5. Repeat the steps for the others.
6. Do NOT wash the car for 48 hours after installation.

Installation Steps of  Weather Shields with Clips

1. Hold up the visors to the door frame to ensure they are correctly aligned.
2. Use a cleaning wipe to clean the areas where the visors will be installed, make sure the area is dry before proceeding to the next step.
3. Insert the metal mounting clips between the window frame and the rubber strip (not window channel).
4. Apply adhesive promoter on the surface of vehicle where you intend to stick visors on.
5. Tear off 5-10cm of each side of the adhesive tape of the visor. Apply pressure to the visor while slowly peeling back the tape, press down firmly to ensure a strong bond.
6. Adjust the mounting clips to line up with the holes of the visors.
7. Place the circular piece on the back side and put the centre pin through the hole on the top, then lock everything in place with the locking pin
8. Repeat the steps for the others.
9. Do NOT wash the car for 48 hours after installation.